Hey Andreas,
Thanks for the tip. Below are the OID’s for the reporting PDU and non-reporting PDU
PDU Reporting Checks:
.1.3.6.1.2.1.1.1.0 Sentry Switched CDU
.1.3.6.1.2.1.1.2.0 .1.3.6.1.4.1.1718.3
PDU Not Reporting Checks
.1.3.6.1.2.1.1.1.0 Sentry Switched PDU
.1.3.6.1.2.1.1.2.0 .1.3.6.1.4.1.1718.4
By doing a side-by-side spot check comparison, it looks like a lot of the OIDs are similar or the same between both devices. The “.1.3.6.1.4.1.1718.4” device is reporting more fields but I suspect thats because it’s a different model and has additional outlets and so forth.
I was reading throughout the forums on building SNMP checks and based on BH2005’s remarks above, do you think its possible that CheckMK is restricting the checks to the working “.1.3.6.1.4.1.1718.3” identifier? If so, is there a way I can “expand” that request to include my other model?
Ben