Monitoring Cisco Device With SNMP

General
11

hi @kdeutsch,

I could use Bulk discovery but I should always run for each device the command check_mk --debug -v --checks cisco_fan -I SW-C2960-B otherwise I don’t see the fan service.

but this happens also with other active check.

for example if I wanted to add CPU service I would have to run check_mk --debug -v --checks cisco_cpu -I SW-C2960-B otherwise by default is not added.

Cisco-CPU
Cisco-CPU1243×116 9.55 KB

but is it correct that it is so? or is there something I am missing?

Thx.
Dario.