Cisco BGP Tunnel Monitoring Plugin Setup

Hi,

Hope you are well has anyone successfully configured the Cisco BGP Plugin to monitor BGP Tunnels.

I have never been able to get this to work I am running Check_MK Raw edition 1.6

If you could detail the steps that would be great

Thanks in advance.

which BGP Plugin you use

this one ??

https://exchange.checkmk.com/p/cisco-bgp-peer

read me are here:

runing well in my 1.6.10 enviroment

Hi @BH2005,

Yes do you mind outlining in detail the steps you used.

Might be user error

to give more Helping Informations i need the real problem you have ???

The Cisco`s are rigth configurted?

Hi @BH2005

See this thread: BGP Error after adding the BGP Plugin

There is no special configuration needed for the BGP checks. Only install the actual mkp.

For further troubleshooting the following outputs are helpfull.

cmk --debug -vvII HOSTNAME (only if you get error messages here)

cmk --debug --checks cisco_bgp_peer -vv HOSTNAME (it is possible that you must do this command two times as some checks are using counters and then two intervals needed to calculate a value - don’t use the ‘-n’ option as this stores no counters)

With these output it is possible to give you some more tips.
The screenshots in your old topic are mixed from WATO and normal Multisite GUI and not so helpful for the troubleshooting.

1 Like

exactly as Andreas has told …

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.