IBM TS3200 - no SNMP checks

CMK version: 2.0.0p25

Hey,

if I’m right CMK brings the plugins to monitor a IBM Tape Library TS3200. I’ve added the Host and enabled SNMP (v3) but the only thing/check I get is “snmp info” and “uptime”.

I can do an snmpwalk with the OIDs and I get an answer from the host. So how do I tell cmk that its a 3200 and it should use the onboard checks?

Josef

Hi Josef,

sounds like maybe the TS3200 has the same issue as the 4300

Hi.

Today I added a new IBM Tape Library check in CheckMk Exchange. It’s available for version 2.0 and above. I think it will be available soon.

Best regards,
Christian

1 Like

oh nice, i’m looking forward to that :slight_smile:

Josef

Any plans how long it takes to become available there?

Josef

Hi.
It’s under review at tribe29 since some weeks. Sorry for that. I add the solution to this answer.

ibm_tl_4500-1.0.0p3.mkp (2,5 KB)

Regards, Christian

1 Like

Thanks for the extension. Do I have to do anything else or just load it up and do a rediscover?

Josef

Josef, you need only to load the extension and make a service dicovery.

Rg, Christian

Does not work for us. Maybe because we have a TS3200 ?

Rg, Josef

Hi Josef.

I think you need the system OID of TS3200. We nwwd to look in the SNMP walk to figure it out.

Rg, Christian

This topic was automatically closed 365 days after the last reply. New replies are no longer allowed. Contact an admin if you think this should be re-opened.